two network cards simatic manager no online access

The amount of Time ( in 100 millisecond units) that the Panel will wait on a Reply after sending a Request. Once the Retry Count has been reached, the Panel will show an Error on the screen and begin trying to send messages again. The Number of Times that the Panel will Retry to send a message if the request does not receive a reply in the specified Timeout Period. The Slot Number of the CPU that is being targeted by C-more. The Rack Number of the CPU that is being targeted by C-more. Refer to the Siemens documentation for the limitations of the various Link Types. If that limit has been reached with the OP Link to the CPU, a different Link Type can sometimes be used. There are limited numbers of connections for each Link Type that can be connected to the PLC.

Most of the time, this should be left at 2 (OP). The IP Address of the S7-1200 or S7-1500 CPU (shown above). Complete the fields on the screen using the information in the table below.Use the TIA Portal (SIMATIC STEP 7) screen on the top of this page as reference. Tree to the left of the window as shown below. Manager window opens by default displaying Panel To set up the Siemens PLC, do the following: Be sure that the Subnet Mask shown matches the Subnet Mask of the C-more Panel.Įnable external access Permit access with PUT/GET communication from remote partner. This is the IP Address to enter in the C-more Programming Software Panel Manager setup window. Both the Rack Number and Slot Number are necessary configuration parameters for the C-more Programming Software Panel Manager setup.Īssign Static IP to the Ethernet Interfaces For the example shown above, the Slot Number is 2. Note the Rack Number of the device to which you are trying to connect. Devices > Device Configuration > click on CPU > Project Information, Rack 0, Slot 1. To configure the S7-1200 or S7-1500 PLC to communicate with the C-more Panel, you will first need to find the Port Settings for your Siemens PLC.įind the Rack and Slot numbers. The C-more panel is the master when communicating with a Siemens PLC. The following information applies only to the Siemens Ethernet ISO over TCP/IP (S7-1200 or S7-1500) PLC compatible with C-more Panels. Siemens Ethernet ISO over TCP/IP (S7-1200 or S7-1500) Setup

Two network cards simatic manager no online access